09-09-2020, 12:06 PM
Getting Participant Responses from a Likert Scale
Required Experiment Builder Version: 1.10.165 or higher
EyeLink Required: Yes
Type: Complete Example
Difficulty Level: Easy
This example illustrates:
This example illustrates how to collect participant responses to survey questions using a 7-point Likert scale. Participants will see a picture for 5 seconds and then will rate how pleasant the picture was. This example shows how to set up multiple clickable regions within a trial and uses the Update_Attribute action to record the participant's response.
**Additional detailed information about the project is given in the notes section for most nodes. To see notes for a given node, either mouse over that node or click on it to display the notes window. If the notes window is not visible, go to the "View" drop down menu in Experiment Builder, select "Properties", and check "Note".
Instructions:
Likert.ebz (Size: 443.83 KB / Downloads: 142)
Required Experiment Builder Version: 1.10.165 or higher
EyeLink Required: Yes
Type: Complete Example
Difficulty Level: Easy
This example illustrates:
- How to use Mouse trigger with a specific clickable region
- How to reference Interest Areas as the clickable region for the Mouse trigger
This example illustrates how to collect participant responses to survey questions using a 7-point Likert scale. Participants will see a picture for 5 seconds and then will rate how pleasant the picture was. This example shows how to set up multiple clickable regions within a trial and uses the Update_Attribute action to record the participant's response.
**Additional detailed information about the project is given in the notes section for most nodes. To see notes for a given node, either mouse over that node or click on it to display the notes window. If the notes window is not visible, go to the "View" drop down menu in Experiment Builder, select "Properties", and check "Note".
Instructions:
- Download the Likert.ebz example from this message
- Launch the Experiment Builder application.
- Unpack the Likert.ebz file to a location on your Experiment Builder PC with "File menu -> Unpack".
- Open the project in Experiment Builder.
- Deploy the project to a new folder.
- Run the Likert.exe from the deployed directory.
Likert.ebz (Size: 443.83 KB / Downloads: 142)